Chefmate CC12 Bedienerhandbuch PDF herunterladen (Seite 14)

Page 14

Simple Maintenance and Repair

DO NOT USE VEGETABLE OIL TO LUBRICATE SLICER.

VEGETABLE OIL WILL DAMAGE THE SLICER!

Sharpener Shafts

It is necessary to lubricate the sharpener shafts with Globe oil weekly.

1. Loosen the sharpener release knob and pull the sharpener up to

remove it (Fig. 14-1).

2. Put several drops of Globe oil on the shaft behind each sharpening

stone (Fig 14-2).

3. Push both sharpener buttons a couple of times to distribute the oil

onto the shafts.

4. Put several drops of Globe oil on the main shaft (Fig. 14-1), place the

sharpener back into position and tighten the sharpener release knob.

5. Wipe off any excess oil that drips onto the slicer.

NOTE: The sharpener and stones can be cleaned with warm water and a brush.

Allow it to air dry. If the sharpener or stones are cleaned it is very important

that all sharpener shafts are lubricated with Globe oil afterwards!

Endweight Slide Rod

The endweight slide rod should be lubricated weekly or when excessive drag is

felt with a few drops of Globe oil.

1. Apply a few drops of Globe oil to the slide rod (Fig. 14-3).

2. Slide the endweight up and down to distribute the oil.

Globe recommends that an authorized Globe service

company perform all adjustments and major maintenance.

By adequately maintaining your slicer,

it will provide years of dependable service.

Figure 14-2

Figure 14-1

Figure 14-3

Endweight Slide Rod

Main Shaft

Sharpener

Release Knob

Shafts

1 2 ... 9 10 11 12 13 14 15 16

Keine Kommentare

Chefmate CC12 Bedienerhandbuch Seite 14